Eagle3D

These are components I’ve created for Eagle3D. You may also want to check out the tutorials on how to create your own components.  http://blog.everythingrobotics.com/tutorials/eagle3d-tutorials/using-google-sketchup-to-create-components/ Components HopeRF RFM12B SMD 433Mhz/915Mhz RF Module Microchip MR24J40MA FCC Approved 2.4GHZ 802.15.4 RF Module Sparkfun SMA PCB Edge PJ-326 3.5mm Jack http://www.switchcn.com/ 900Mhz GSM SMA Antenna attached to PCB SMA … Continue reading Eagle3D

Step 4

Tweaking the Settings Now we have added the component into Eagle3d we need to tweak and fine-tune the settings. Now render your PCB, more than likely a couple of problems will show up.  The first is your component is very small.  so we need to tweak the scaling from within the component file we recreated … Continue reading Step 4

Step 3

Integrating into Eagle3D Now we have converted the file to work in Eagle3D we now need to tell Eagle3D how to use it. Add your include file to the user.inc file #ifndef(__user_inc) #declare __user_inc = true; #include "MRF24J40MA.inc" #end Now open and add the following to the end of 3dusrpac.dat (found in the Eagle3D install … Continue reading Step 3