Eagle3D

These are components I’ve created for Eagle3D. You may also want to check out the tutorials on how to create your own components.  http://blog.everythingrobotics.com/tutorials/eagle3d-tutorials/using-google-sketchup-to-create-components/ Components HopeRF RFM12B SMD 433Mhz/915Mhz RF Module Microchip MR24J40MA FCC Approved 2.4GHZ 802.15.4 RF Module Sparkfun SMA PCB Edge PJ-326 3.5mm Jack http://www.switchcn.com/ 900Mhz GSM SMA Antenna attached to PCB SMA … Continue reading Eagle3D

Protocol

Protocol: Full Detail can be found here on the wiki - http://wiki.everythingrobotics.com/index.php?title=Draft_Proposal The trigger packet transmitted is 7 bytes long.  Preamble(3 bytes), Sync(2 bytes), trigger command (1 byte) and CRC byte. The Preamble is used by the the RF module to tune the Receiver. The Sync word is used by the RF modules receiver circuit to … Continue reading Protocol

PICAXE Stuff

  My PICAXE Projects BuzzBot Blog - A R/C Toy being converted to a robot using the PICAXE LED Switch - Interesting Sensor Concept using an LED as both a Light Emmiting Device and as a Light Sensor

BuzzBot – PicAxe Frustrations

Frustrations  I have to make some decisions on what direction I need to go with my buzzbot project, basically I have been frustrated with some short comings of the PICAXE microcontroller.  The main being lack of any onboard timers and having only one common interrupt available.  Also I think that I'm trying to fit too much onto one of these babies.  … Continue reading BuzzBot – PicAxe Frustrations

About

This blog is a collection of my projects and things I’m doing at the time. Unfortunately due to a busy life (like most out there) the blog may see some alot of in-action for periods of time, however don’t despair, as I get around to updating things eventually and the blog posts go through a burst … Continue reading About